Using the 602 kit was easy and above my expectations. At the rating of the kit I shouldn't have been able to do the area I did. I can't wait to see how much of my house I can do with the next order.

Ian M.
Barryton, MI

I recently used the 202 kit from Spray Foam Direct and found it the EASIEST and FASTEST foam kit I have ever used. So simple a kid not knowing anything could just about use it. The company itself responded to every phone call and every email I sent them immediately. The foam went on fast with no overspray whatsoever. They say it would cover so much and it is very exact. When I finished, I had none left.

I used the product this morning on a 45 x 8 foot wall. Not solid of course, IT worked great. Perfect product. 'first time I used anything like that so was leery. Needn't be. Just read directions, make sure it is warm enuf, have a helper shaking and moving all the time. Fantastic product.
Tom W.
Yuma, AZ

I recently used the Foam it Green 102 Spray Foam Insulation Kit and two Foam It 12 Patch and Repair Kits to insulate below the new floorboard of my 1962 22' Airstream Safari I am completely rebuilding. This area will be completely wrapped with aluminum so temperature and sound insulation will be vital as well as moisture protection. Following the re-installation of the top shell, I plan to use Foam It Green Spray Foam Insulation within the entire interior prior to re-installing the inner aluminum skin. Though this project will not be "road-ready" for some time, I look forward to being comfortable and saving valuable energy inside my Foam It Green "shell" while traveling. Foam it Green was so easy to use.

Russell G.
Rancho Cucamonga, CA

Read more...

This was by far the easiest and smoothest application of an insulating product I have ever done. The videos on the Foam-it Green site are accurate and show you exactly how do properly use the foam and get great results. I used the spray foam to insulate my basement joists and sill plate. And now that Ive finished there is a noticeable improvement in temperature, air flow and noise reduction. highly recommended product!! It's so easy to use with the gun and the tanks pre attached I was able to very quickly get to work without confusion. The temperature indicators on the tanks were also a great help to let me know I was in the "green" zone to start spraying.

Jamie B.
Yardley, PA

I put the foam in a house that was built in 1920 and to feel the difference is wonderful,,,the power bill went down by 60%! Thank you. In the long run - 3 years - it will come back to me then it is free! It was also easy enough to apply.

Richard R.
Inverness, FL

This is a new construction project of sorts. I am building a living quarters inside of an airplane hangar at a residential airpark. The first wall I built fits up against the outside wall of the hangar. The hangar is a "pole barn" style construction if you are familiar with that. I already had R10 fiberglass on the hangar wall, and just wanted to add a bit more before it got sealed up behind the stud wall. It was a test to see if I could handle spray foam insulation by myself. Your product worked as advertised and was easy enough to apply.

Topp R.
Flower Mound, TX

Read more...

We live in a 1930's Tudor, with no insulation in the walls. As part of our master bedroom/bathroom upgrade we used FoamItGreen slow rise. These rooms are now the warmest/quietest rooms in the house. On top of the comfort we got to keep our lathe and plaster walls in mint condition. No more drafts and street noise. Also no dust and debris to demo the wall, insulate, and the use Sheetrock (which can never compare to the feel and hardness of lathe/plaster).

The two most beneficial values of Foam are the warmth/quiet from the insulation, and no muss or fuss of installation by getting to keep our plaster walls.

Simon M.
Washington, DC

We have been so pleased with the product which is simple to use, and works wonderfully to insulate against the cold Wisconsin winters. The best part is the wonderful customer service from start to finish. I know up front what my costs will be and for a small restocking fee I can return canisters if the project doesn't use as much as originally planned. Great product with great customer service...it doesn't get any better than that.

Cynthia K.
Madison, WI

Read more...

Foam it Green really makes a big difference and I am very pleased with the product.

Guy H.
New Carlisle, OH

It should have a "spray foam for dummies" label-it is that EASY to use! Quick install and very effective! Our room was immediately warmer and the walls were made sturdy. Videos to watch in preparation of install have me confidence that I could do this job. Easy, fast, quiet, and mess-free!

Willie H.
Crossville, TN

I am finishing my basement, myself, and am very particular with the products I select and making sure things are done right. With that said, I have reviewed pretty much all of the DIY spray foam kits that are available for my rim joists and had selected Foam It Green for a number of reasons that lead the other competitors. Their system is as close to "fool proof" as you can get, but like anything else, you need to read the instructions, view the videos, and you'll be on your way.

I must say, their customer service is by far more satisfying and caring than any other business I have dealt with in the past few years. They went beyond the call of duty to ensure I could complete my project. If you are thinking of purchasing a DIY spray foam kit, Foam It Green is the real deal! Thank you Foam It Green

Raymond L.
Centreville, VA

Living here in the northeast, we as well as many folks experienced a cold snowy winter not seen quite for some time equating in high heating costs. Installing Foam it Green on the basement walls as part of a finished basement project I was able to cut my heating costs drastically. With the installation of two small propane heaters in the basement I'm now heating twice the square footage for approximately 30% less than I did during last years mild winter. There are a few more projects I can do to improve the energy efficiency of our home. When that time comes, I will be incorporating Foam it Green in my construction plans.

Michael G.
Howard, PA

This product was delivered on time by a lite truck line. After watching some of the videos I setup for spraying the walls of my new steel garage. I wanted a product that was a moisture and thermal barrier for my steel building in Florida. It was easy to apply and I did the whole 35'x30' building walls in two sessions. What a great product, it expanded to fill the walls about an inch thick. Now it is a much quieter building along with the obvious moister and thermal barrier. Now I have to sheet rock and eventually air condition my garage.

Don C.
Port Richey, FL

My home had a pretty bad roof leak that had been leaking for several years. Once discovered there was a great deal of wood repair. When the sheathing was removed, all of the original foam went with it. It was about 75 square feet and because of cost I searched for a way to repair the foam myself. The cost of Foam it Green was very economical. Also great was the ease of use. I was in the attic in a very tight area. I did not have any problems with the spray reaching the tight areas.

Robert B.
Winter Park, FL

So far, great product. Being a contractor (Electrical) have passed this on to my contractors who loved it and have bid it into some of there jobs. Why call the big guys for a small job when you can do it yourself and you know when your going to be there. No delay on jobs. I just put it into a bid for a dog house, it made sense. Should I ever need in the future I know where to go.

Blair H.
Potomac Falls, VA

Yes we finally got our house sprayed with FOAM IT GREEN. First shot at it, the OD. temp was 20 took awhile to get walls up to temp. but it worked out well. The fan tips seem to plug up quickly. So sprayed most with out it. Second time, 60 OD. temp. Went a lot better, hope to see significant improvement in our new house. Last house is only 200 yards away, nothing around to stop the wind, we had drafts though every light switch and outlet. It took 1.5 hrs to spray 1- 602 kit, spayed 2 kits that day and finished all ext. walls on main floor. I have 2 kits left to start on basement and rim joist. Probably will need 3 more kits this summer. Your product worked very well, and have couple co-workers asking about it.

Steve L.
Pierre, SD

From the beginning it has been nothing but outstanding. When we place the order we received a follow-up call as well as emails ensuring us that if we had problems, questions or concerns Foam-it Green would be there, great customer service! As for the product itself it was extremely easy to use and it did its job. We had a drafty attic and it was put to the test this weekend and where we could once stand and feel the wind blow we felt nothing. AWESOME!

Ryan H.
Wichita, KS

Read more...

The stuff is impressive and looks cool too. I know of nothing better than stopping air infiltration along basement rim joists. Previously I used method of canned expanding foam along the seams. It helped a little, but did not insulate very much or cover as well. This has been the colder winter in decades and the basement and house has not been as cold. My girlfriend lives in a condo built in 1993 and kitchen pips froze because the builder merely put insulation in the joist pockets where the some of the walls extend beyond the foundation and covered the bottom with aluminum flashing. I recommended the closed call spray foam to one of the condo association trustees.

Ronald A.
Cleveland, OH

After much research I took the plunge. My first purchase ever was pallet full of 602 kits. I tackled a whole house built at the turn of the century. Had wormy chestnut logs for floor joists. So lots of gaps and uneven areas. There was near zero insulation in the home. I did a full cavity fill on every place I could put it. Wow what a difference, immediate results. We had purchased the home in Dec 2012 and by summer 2013 had spent about $2000.00 in fuel oil with the thermostat set at 50 degrees. Just warm enough to work on the building and keep the pipes from freezing. In the fall of 2013 , I installed the foam. It is now spring of 2014 and I have used $850.00 so far in heating and will probably need an additional $150.00 to complete the year.

Don M.
Johnstown, PA

Read more...

I recently purchased your product, and was pleased with the results. I would like to offer a suggestion, that I think would improve your safety instructions. I am a six foot male, and found that the body suit, gloves, goggles, and foot coverings were adequate. The problem that I experienced, was that as I reached to spray the upper portion of an 8 foot high wall, that the wrist section of my spraying arm became exposed, creating skin exposure to the chemicals. An extended glove, or at the least, a warning about this hazard, would have been a more complete safety precaution. I hope this suggestion is of value.

Note from Foam it Green: James, we are happy to provide XXL or XXXL suits for tall sprayers, which would keep wrists covered. Just ask at the time of purchase. Thank you!

James B.
Lake Worth, FL

Foam it Green is the best money I have ever spent, and I plan on spending more in the future. The ease of using the product and the results are outstanding! Have to give you all a 5 Star rating!

Eugene R.
Creston, IA

Your product was great. The set up was simple and the directions explained how and why which for me made the job go even faster. I sprayed the interior of my house walls and ceilings. It was a two step process first I added two inches of board foam a R-12 value. That left me with a full two inch cavity for the Green it Foam and another R-14 giving me in a true 2x4 inch wall R-26.

Irving S.
Poughkeepsie, NY

Read more...

Just use your product and loved it. It done the job great.

Mark H.
Spencer, WV

Both products worked like a charm! Did my walls by filling them with slow, ceiling with regular. free stuff was a blessing! I just could not believe how simple and fast it was. Tip: Filling the walls I counted 15 seconds twice (30 seconds each) to fill bottom and top cavity worked perfectly.

Adam M.
Los Angeles, CA

This project was for Habitat for Humanity house, I am a volunteer for our local chapter. We installed the foam in poured concrete basement walls for additional living space in this house. Everyone is very pleased with the product and it the need arises again we will us the product. I have a project at home I want to use it on, but I have not made the time to work on my own home yet....

Keith T.
Marietta, OH